Garage Door Garage Door Sensor Installation Pomona, NY

Garage Door Garage Door Sensor Installation Pomona, NY

We tailor garage door sensor installation to Pomona's housing and climate. With predominantly single-family homes with attached garages, plus a core of older in-town residences and warm, wet summers and cold winters with snow and ice, driving repeated freeze-thaw cycles on exterior hardware, the durable choice is rarely the cheapest part — and we'll explain why.

Because Pomona has warm, wet summers and cold winters with snow and ice, driving repeated freeze-thaw cycles on exterior hardware, the doors here age differently than inland or coastal homes elsewhere. The usual culprits are freeze-thaw cycles that crack seals and loosen hardware, summer heat and humidity that swell wood doors and rust steel, and winter snow and ice load on doors and tracks — exactly what our techs come prepared for.

We've fixed thousands of doors around Rockland County, and the pattern holds in Pomona: doors frozen to the slab on cold mornings, ice- and snow-jammed tracks, cold-snapped torsion springs in deep winter, and corroded low brackets from winter slush. None of it should leave you without a working garage for more than a day.

Photo-eye safety sensors are required by UL-325 on every garage door opener manufactured since 1993. They detect obstructions in the door's path and either reverse the door (during close) or refuse to start (when activated). When sensors are misaligned, dirty, sun-blinded, or failed, the door either refuses to close at all or — worse — closes without sensing an obstruction. Our sensor installation service replaces failed sensors, realigns drifted brackets, cleans the eye optics, and verifies auto-reverse on a real obstruction test.

Replacement eyes are brand-specific (LiftMaster has a different connector and signal pattern than Genie). We stock the major brands and most legacy models. Brackets occasionally need replacement when corrosion has degraded them or impact has bent them. Bracket alignment is critical — eyes that are slightly off-aim trigger intermittent close failures that drive homeowners crazy.

Every visit ends with an obstruction test: a 1.5-inch (3.8 cm) tall object placed under the door at three positions across the opening. The door must reverse when it touches the object. This is the UL-325 baseline — if the door doesn't pass, the install isn't complete. We document the test results on the work order.

Signs you need garage door sensor installation